Sony VPHG90E Mode D'emploi page 15

4 RGB keys
Adjust the picture.
APA: This key does not function with this projector.
DOT PHASE: This key does not function with this
projector.
SIZE: Enters the size adjustment mode for the input
signal in the pro-user mode. Next adjust the size of
the picture using the four arrow keys. Each time
you press this key, the COARSE and FINE modes
are switched alternately.
B: to reduce horizontal size
b: to expand horizontal size
V: to expand vertical size
v: to reduce vertical size
SHIFT: Enters the shift adjustment mode for the input
signal in the pro-user mode. Next adjust the
position of the picture using the four arrow keys.
The picture shifts in the direction of the arrow on
the pressed key. Each time you press this key, the
COARSE and FINE modes are switched
alternately.
5 COMMAND ON/OFF switch (only for the
remote commander)
No keys on the remote commander except the LIGHT
button 1 function when this switch is set to OFF.
This saves battery power when a button is pressed
inadvertently.
6 CENT R/B keys
Enter the centering adjustment mode of the red and
blue in the pro-user mode.
R: Press to enter the red centering adjustment mode.
B: Press to enter the blue centering adjustment mode.
Perform the centering adjustment using the four arrow
keys.
7 MEMORY key
Stores various adjusted data into memory.
8 ON/SYANDBY keys
Turn on and off the projector when the MAIN
POWER switch on the projector is set to ON.
9 MENU key
Displays the main menu. Press it again to turn off the
menu.
0 Arrow keys
Adjust the value or select the item in the menu.
!¡ ENTER key
Stores the settings in the menu, or selects and displays
the index number.
!™ FUNCTION key
Press to use the extended functions.
!£ RESET key
Resets the adjusted levels to the factory preset or
service adjusted levels.
!¢ POSITION +/– keys
Select the position to be adjusted on the screen in
focus, registration or blanking adjustment mode.
Also, set V SHIFT to WIDE or NARROW in RGB or
HDTV input signal's SHIFT adjustment mode.
!∞ PICTURE CONTROL keys
Adjust the picture conditions: CONTR (contrast),
BRIGHT (brightness), COLOR, HUE and SHARP
(sharpness).
!§ VOL (volume) +/– keys
These keys do not function with this projector.
!¶ SWITCHER/VIDEO MEMORY/INDEX select
switch
Selects the function of the SWITCHER/VIDEO
MEMORY/INDEX keys.
SWITCHER: to select the input from the PC-3000 or
the PC-1271/1271M Signal Interface Switcher.
VIDEO MEMORY: to select the set and adjusted
video memory data.
INDEX: to select a projector by its index number
when multiple projectors are used.
!• SWITCHER/VIDEO MEMORY/INDEX keys
When the SWITCHER/VIDEO MEMORY/
INDEX select switch is set to SWITCHER
When the PC-3000 or the PC-1271/1271M Switcher
is connected to the projector, press a number key (1 to
8) to select the input from the switcher. Number key
9 and the 10/0 (ALL) key do not function.
To select an input when multiple switchers are
connected, set the SWITCHER/VIDEO MEMORY/
INDEX select switch to SWITCHER, then press the
SW NO/OFF/GROUP key. Next press the switcher
number (1 to 8) and the input number (1 to 8) in
sequence. Be sure to press the keys one after another
within 2 seconds.
e.g. To select input 4 of switcher 2, press the keys as
follows:
SW NO n 2 n 4. 15
Overview (GB)