Sony VPHG90E Mode D'emploi page 50

Setting the Index Numbers
50
(GB) Installation/connection examples
Notes
• Do not set the same device index number on multiple projectors in the
same system.
• Do not set the device index number to "00." If you do, the projector will
be operated only with the keys on the control panel. It cannot be
controlled with the wired or wireless Remote Commander, or with an
external equipment via the PJ COM connector.
Notes on setting of the index number
• Set the same group index number for all equipment of the same
system connection (those on the signal route between the signal source
and the projector).
PC-3000
*
Signal flow
PC-3000
*
Signal flow
Projector
*
PC-3000
*
Signal flow
Projector
*
Signal flow
Projector
• Set the correct group and device index numbers and the switcher
number.
Do not set the same device index number or the same switcher number in
one group.
For example, if there are different pieces of equipment with the switcher
number 1, the error message will appear when the SYS SET key is
pressed.
• Set the switcher that outputs the signal to the projector to number 1.
PC-3000
PC-3000
Projector
Notes on connections when two or more switchers are used
• Mount the IFB-12/12A interface board to the slot 1 of the number (n)
switcher and connect the output connector of the number (n+1)
switcher to the IFB-12/12A.
• You can attach the IFB-12/12A signal interface board (when the IN/
OUT switch is set to OUT) only to the number 1 switcher.
Set the same group index number.
Set the different group index number
for two systems.
Set the same group index number.
* PJ COM IN/OUT connections
*
Set this switcher to 1.
*
* PJ COM IN/OUT connections