Hella OWS Série Manuel Technique page 32

30
2.1.2 Permanent
Mounting with Large
Rubber Pad
The enclosed seals are not
required.
Insert the M10 bolts into the
left and right anchoring
bridges of the bracket.
Install the rubber pad on the
bottom of the OWS.
Position the device on the
vehicle roof and at the same
time guide the cable through
the cable opening and the
bolts into the drilled holes.
After that screw OWS down
tight.
After mounting, make sure the
beacons are in vertical
position. Differences of level
can be compensated by
loosening or tightening
individual bolts.
Make sure beacons are visible
in all directions (360°).