Walther PILOT Mini FB Mode D'emploi page 13

Contents
1 General Information
2 Technical Description
3 Safety Instructions
4 Assembly
5 Operation
6 Retooling and Repairs
7 Cleaning and Maintenance
8 Troubleshooting
9 Disposal of Cleaning and Servicing Substances
10 Technical Data
1 General Information
1.1 Identification of Model Version
Models: Manual Spray Guns PILOT Mini-HD (high pressure)
Manual Spray Guns PILOT Mini-MD (medium pressure)
Type: PILOT Mini-HD Gravity-Feed Cup
PILOT Mini-HD Material Connection
PILOT Mini-MD Gravity-Feed Cup
PILOT Mini-MD Material Connection
Manufacturer: WALTHER Spritz- und Lackiersysteme GmbH
Kärntner Str. 18-30
D-42327 Wuppertal • Germany
Phone: 00 49 / 2 02 / 787-0
Fax: 00 49 / 2 02 / 787-217
www.walther-pilot.de • Email:info@walther-pilot.de
1
1.2
The manual spray gun PILOT Mini is designed exclusively for use with sprayable
media, including water-based and aggressive media, such as:
• paints and laquers
• greases, oils and corrosion preventives
• ceramic glazes
• pickling solutions
Since all wetted parts are made of stainless steel, water-based media may be
used as well.
If you have any questions, please contact WALTHER Spritz- und Lackiersysteme
GmbH, Wuppertal.
Sprayable material should only be applied to work pieces or similar objects.
The temperature of the material to be sprayed should at no time exceed 43° C.
The term 1.2 Normal Use also implies that any and all safety warnings and instruc-
tions laid down in these operating instructions have been read, understood and are
duly complied with.
This equipment complies with the explosion protection requirements of Directive 94
/ 9 / EC (ATEX 100a) for the explosion group, equipment category and temperatu-
re class indicated on the type plate. When using the equipment, the requirements
specified in these Operating Instructions must be observed at all times.
The technical data indicated on the equipment rating plates and the specifications
in the chapter "Technical Data" must be complied with at all times and must not be
exceeded. An overloading of the equipment must be ruled out.
The equipment may be used in potentially explosive atmospheres only with the
authorisation of the relevant supervisory authority.
The relevant supervisory authority or the operator of the equipment are
responsible for determining the explosion hazard (zone classification).
The operator must check and ensure that all technical data and the marking of the
V 10 151
equipment in accordance with ATEX are compliant with the necessary require-
V 10 152
ments.
The operator must provide corresponding safety measures for all applications in
V 10 141
which the breakdown of the equipment might lead to danger to persons.
V 10 142
If any irregularities are observed while the equipment is in operation, the equip-
ment must be put out of operation immediately and WALTHER PILOT must be
consulted.
Grounding / Equipotential Bonding
Measures must be taken to ensure that the spray gun is sufficiently grounded
(earthed) by means of a conductive air hose (maximum resistance 10 6 Ω).
Normal Use
2