Transport And Start Up; Transport And Installation; Assembly - Jet OES-80CS Mode D'emploi

5. Transport and start up

5.1 Transport and installation

For transport use a forklift or hand
trolley. Make sure the machine does
not tip or fall off during transport.
The machine is designed to operate in
closed rooms and must be placed
stable on firm and levelled ground.
The machine can be bolted down if
required.
For packing reasons the machine is
not completely assembled.

5.2 Assembly

If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
a mild solvent.
Cabinet stand assembly
Attach the four rubber pads (A, Fig. 1)
to the bottoms of the side panels with
4 screws, 4 flat washers and 4 hex
nuts.
Fig 1
Attach the side panels (C) to the front
panel (D) with 4 hex cap bolts, 8 flat
washers, 4 lock washer, and 4 hex
nuts (E).
Mount the shelf (F) to the inside of the
stand with 2 pan head screws M5 (G)
and 2 lock washers.
Finish stand assembly by attaching
rear panel to side panels. Make sure
stand is sitting evenly on a level
surface before tightening hardware.
Fig 2
WARNING:
Main unit (A) is 95kg heavy!
Use great care and adequate
resources when lifting the unit up onto
the stand (B).
Through the door in the cabinet (E)
attach main unit to stand with two hex
cap bolts and two flat washers (D).
Sanding belt installation
Unlock the platen assembly
(A, Fig. 3).
Fig 3
Tilt sanding unit to the vertical
position, and lock handle.
Remove the belt guards by
unscrewing two lock knobs (B Fig. 4).
Take out sanding belt and fence
packed behind the belt guard.
5
Fig 4
Move the handle (C) to the no-belt-
tension position.
Place belt on both rollers so that the
edge of the belt is even with the edge
of the rollers.
Observe direction arrow on inside of
sanding belt. Make sure that direction
arrow on belt matches direction
indicator on the belt cover.
Tension the belt if in place.
Rotate the belt by hand in the
direction indicated by the arrow on the
belt guard (If belt tracking needs
adjustment see "Belt Tracking
Adjustment" chapter 8.1)
Drum guard assembly
Attach the drum guard (C, Fig 5) with
four M4x20 screws (A).
Two rectangular spacers (D) need to
be placed between hinges (B) and belt
cover (E).
Note: Orient the rectangular spacers
so the slightly rounded side sits
against the hinge.
Fig 5
Attach the connection plate (F) with 2
washers (G) and 2 lock knobs (H).
The slotted side of the connection
plate attaches to the drum guard (C).
When opening or closing the drum
guard, slightly loosen both lock knobs.