Maintenance And Inspection; Trouble Shooting; Available Accessories - Jet OES-80CS Mode D'emploi

Fig 15
Slightly loosen the four motor mount
nuts (A, Fig. 15) just enough so the
tracking bolts (B) can make an
adjustment.

8. Maintenance and inspection

General notes:
Maintenance, cleaning and repair
work may only be carried out after
the machine is protected against
accidental starting by pulling the
mains plug.
Check sanding belts regularly for
faults. Replace a defective sanding
belt immediately.
Inspect the blade tracking regularly.
Take away the belt tension if the
machine is not in use for a longer
period.
Clean the machine regularly.
Inspect the proper function of the dust
extraction daily.
Defective safety devices must be
replaced immediately.
All protective and safety devices must
be re-attached immediately after
completed cleaning, repair and
maintenance work.
Repair and maintenance work on the
electrical system may only be carried
out by a qualified electrician.

9. Trouble shooting

Motor doesn't start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
*Overload has reacted-
Wait and reset overload cut-off.
Sanding belt slips
*Sanding belt is stretched-
install new sanding belt.
*Too much applied pressure
move work piece while sanding.
Machine vibrates excessively
*Stand on uneven floor-
adjust stand for even support.
*motor mounts are loose-
tighten motor mount bolts.
Abrasive belt keeps tearing
*Belt is running the wrong direction-
observe arrow on the sanding belt
Sanded edge not square
*Table not square to sanding platen-
Adjust positive stop for 90°.
Sanding marks on the wood
*Work piece was held still-
keep work piece moving.
*Wrong grit sanding belt-
use coarser grit for stock removal
and fine grit for finish sanding.
*Feed pressure too high-
never force the wood.

10. Available accessories

Stock number 60-0505
Abrasive strip cleaning stick
Stock number 708118
Mobile base up to 250kg
Refer to the JET-Pricelist
for various grit sanding belts.
8