Washer-Drier Preparation; Battery Installation; Solution Tank Fi Lling - RCM BYTE Série Notice D'utilisation Et Entretien

Table des Matières

Les langues disponibles

Squeegee assembly

For packaging reasons the squeegee might have been supplied dismantled from the machine. Assemble the squeegee on the washer-drier

tow plate as follows:

- lower lever 1

- insert pins 2 on the tow plate 3 and tighten the knobs 4

- assemble the suction tube 5 on the squeegee.

Squeegee regulation

For maximised functioning of the squeegee, the back blade "A" must be slightly bent during operation.

In this way liquids are collected by the front side of the blade. Regulate the incline of the squeegee by means of the knob 6, looking for the

best angle with respect to the ﬂ oor (as shown in the ﬁ gure). Regulate as follows:

- clockwise rotation increases incline

- counter-clockwise rotation decreases incline

TTENTION

F THE BATTERIES TO BE INSTALLED ARE

THE ELECTRONIC CONTROL UNDER THE CONTROL PANEL

FIGURE A".

The batteries are placed in their special bay in the solution tank, which can be accessed by releasing the drainage tube 1 and removing the

recovery tank 3.

Proceed as follows to install batteries:

- verify that the recovery tank is completely empty

- remove the tank

- insert and connect batteries as represented in battery connection diagram 4

- replace the recovery tank and re-attach the drainage tube.

TTENTION

GEL

LEAD

HARGING

Verify that the recovery tank is completely empty.

Fill the solution tank via the mouth 9 (ﬁ g.1) to deposit clean water at a maximum temperature of 50°C, add diluted liquid cleanser in the

concentration dosage recommended by the manufacturer.

To avoid the formation of excessive foam, we recommend using the minimum amount of suggested cleanser or adding an anti-foam

product.

Always utilise protective gear (gloves, shirts, etc.) when handling detergents or when emptying the tank of recovery liquid.

TTENTION

LWAYS USE ANTI

FOAM DETERGENTS

O NOT USE UNDILUTED ACID