Section 4 Troubleshooting - Keurig Hot COMMERCIALE Série Manuel D'utilisation

P18 20162461 T5274_K150P_UCG_FINAL.pdf 4C(CMYK) ZB2319 2016-11-02 Size:8.5X5.5in
SECTION 4
Troubleshooting
SITUATION SOLUTION
Brewer does not Plug the brewer into an independent outlet.
•
have power Check to be sure that it is plugged in securely.
•
Make sure that the brewer is powered on and
•
LCD Screen is illuminated.
Reset circuit breaker if necessary.
•
Plug into a different outlet.
•
Brewer will After placing the K-Cup
•
not brew make sure the Handle is pushed down securely and the
LCD Screen reads "READY TO BREW" with the BREW
Button flashing, then press the BREW Button.
The exit needle may be clogged (refer to page 15).
•
LCD Messages
• I n plumbed mode, if the water flow has been interrupted,
LCD Screen will state "WATER FLOW INTERRUPTED,
TO RESET, PLEASE PRESS BREW BUTTON."
Press BREW Button to resolve this issue.
• If the messages persist after following these
instructions, contact your Keurig Authorized Distributor.
Brewing a partial cup
pod in the K-Cup Pod Holder,
® ®
If any problems persist, contact your Keurig Authorized Distributor.
18
SITUATION SOLUTION
Chlorine or mineral Be sure to use filtered water. If you have any
•
taste in coffee questions, contact your Keurig Authorized
Distributor.
The exit needle may be clogged (refer to page 15).
•
Clean the K-Cup
•
and rinse under faucet (refer to pages 14-15).
"Descale" the brewer (refer to pages 15-16).
•
If you have repeated the descale procedure on
•
your brewer two times and it is still only
brewing a partial cup, contact your Keurig
Authorized Distributor.
The time is not The time will not be displayed on the LCD Screen
•
displayed on the unless you have set it. To set the clock, follow
LCD Screen the procedure on page 11.
If power is interrupted to the brewer, you will
•
need to set the clock again using the procedure
on page 11.
Brewer shuts Check to make sure that the Auto Off time
•
off or turns on and/or On/Off time features have not been set.
automatically To do this, enter the Menu Mode (page 9) and
follow instructions to reset (page 12).
Pod Holder Assembly if necessary
®