Draining The Brewer - Keurig Hot COMMERCIALE Série Manuel D'utilisation

P17 20162461 T5274_K150P_UCG_FINAL.pdf 4C(CMYK) ZB2319 2016-11-02 Size:8.5X5.5in
Purging the Brewer
28
fig.
If your brewer has not been used for more
than one week, you should purge the water
Place Mug,
from the internal water tank.
Select
Brew Size
4 Oz.
Follow Draining the Brewer instructions
1.
on page 17.
6 Oz. 8 Oz.
Once drained, re-connect brewer to power
2.
source and turn on.
10 Oz. 12 Oz. 3. When the brewer indicates "READY," place
a large mug on the Drip Tray Plate and
select Large Mug (10 oz. serving) brew size
from the Select Brew Size Menu (fig. 28).
4. Discard water.
5. Repeat steps 2-4 two more times to
29
fig.
completely purge water from the internal
water tank.

Draining the Brewer

Turn off the brewer, unplug it, and allow the
1.
brewer to cool approximately 30 minutes.
Turn the brewer around so the back is
2.
Drain tube
facing out. Unscrew the small knob to
Drain tube
connected to the
connected to the
release the back panel, remove the panel
cold water tank.
hot water tank.
from the brewer, and set it aside. If the
screw is tight, you may need to use a
flathead screw driver.
3. Pull both the tubes downwards until the ends are free. Over a large
pitcher, remove the plugs (fig. 29) and drain the water from the cold and
hot water tanks, respectively.
CAUTION: If the brewer was not allowed to cool sufficiently, the water draining
from the tube may be very hot. Recap the tube
when finished, re-insert the tube and screw the panel back onto the brewer.
If you need assistance with your brewer, please contact your Keurig
Authorized Distributor.
Storage
Drain the internal water tank before storing and ensure that you store
your brewer in a safe and frost free environment. It is suggested to store
your brewer in the upright position. If you store the brewer in a cold
environment, you run the risk of water freezing inside the brewer and
causing damage. When you prepare to use it after storage, we
recommend running three cleansing brews without a K-Cup
you plan to move your brewer to a different location, turn the brewer off,
unplug it and empty the internal water tank. If your brewer has been in
an environment below freezing, please be sure to let it warm to room
temperature for two hours before using.
17
. NOTE: To avoid losing parts,
pod. If
®