Descaling Procedure - Keurig Hot COMMERCIALE Série Manuel D'utilisation

P16 20162461 T5274_K150P_UCG_FINAL.pdf 4C(CMYK) ZB2319 2016-11-02 Size:8.5X5.5in
SECTION 3 Cleaning & Maintenance

Descaling Procedure

STEP 1: FIRST DESCALING SOLUTION RINSE
• Press the Power Switch to power on the brewer.
• Place a large mug on the Drip Tray Plate and run a cleansing brew using
the largest brew size. Do not add a K-Cup
mug into the sink.
STEP 2: SECOND DESCALING SOLUTION RINSE
• Repeat the brew process without a K-Cup
indicated. Let the brewer stand for at least 30 minutes while still on.
• After 30 minutes, discard any residual solution through the drain tubes.
STEP 3: FRESH WATER RINSE
• Ensure the internal cold water tank is filled with fresh water.
• Place a large mug on the Drip Tray Plate and run a cleansing brew using
the largest brew size. Do not add a K-Cup
mug into the sink.
• Repeat brew process until you have completed at least 12 brews using the
largest brew size. You may need to refill the cold water tank at least one
time during this process.
NOTE: The cleaning action of Keurig Descaling Solution may result in a foam
®
dispensed from the brewer. This is natural, as the solution is reacting with the
scale inside. For a brewer that is heavily scaled, the brewer may not fill properly
after the descaler is added. If this occurs, you may see only a small or no output
dispensed followed by the sound of air blowing out. If this occurs:
• Turn off and unplug the brewer.
• If there is Keurig
• Plug the brewer back in, power on, and repeat the Step 3 Fresh Water
pod. Pour the contents of the
®
For further descale information please contact your Keurig Authorized Distributor.
Service
pod, until "ADD WATER" is
®
Beyond these recommended cleaning and maintenance procedures this
brewer is not user serviceable. For service, please refer to the Warranty
section of this guide.
pod. Pour the contents of the
®
16
Descaling Solution in the cold water tank, discard the
®
contents through the drain tubes, (follow Draining the Brewer instructions
on page 17), rinse the Water Reservoir thoroughly and refill with water.
Rinse cycle. The brewer should begin to function normally as the solution
is rinsed out and the scale is removed. If problem persists, allow the
brewer to sit unplugged for at least 30 minutes before continuing with
the rinse.