Descaling - Keurig Hot COMMERCIALE Série Manuel D'utilisation

P15 20162461 T5274_K150P_UCG_FINAL.pdf 4C(CMYK) ZB2319 2016-11-02 Size:8.5X5.5in
Grasp the top of the K-Cup
26
fig.
one hand while pushing up on the bottom of the
K-Cup
®
other until it releases (fig. 25). After cleaning,
align the K-Cup
using the two front ribs as a guide, and snap
!
them into place from the top.
2. Cleaning the Funnel —
removed from the K-Cup
pulling on it until it pops off (fig. 26). The Funnel
is dishwasher safe. To replace it, just snap it
back onto the K-Cup
3. Cleaning the Exit Needle —
located on the inside bottom of the K-Cup
Holder Assembly. Should a clog arise due to
coffee grounds, it can be cleaned using a paper
27 clip or similar tool. Remove the K-Cup
fig.
Holder Assembly and detach the Funnel. Insert
the paper clip (as shown in fig. 26) into the exit
needle to loosen the clog, then flush with fresh
water. The K-Cup
be placed onto the top shelf of a dishwasher.
NOTE: Use low temperature cycles in
the dishwasher.
4. Cleaning the Puncture Plate — The Puncture Plate can be removed by
grasping the finger grips of either side and pulling forward (fig. 27).
Once removed, spray the Puncture Plate with detergent, brush clean and
rinse if necessary. Be sure to replace the Puncture Plate after cleaning to
ensure proper brewer operation.
Pod Holder with
®
Pod Holder from underneath with the
Pod Holder with the opening
®
The Funnel can be
Pod Holder by
®
Pod Holder.
®
The exit needle is
Pod
®
Pod
®
Pod Holder Assembly can
®
CAUTION: There are sharp needles that puncture the K-Cup
K-Cup Pod Holder and in the bottom of the K-Cup
®
of injury, do not put your fingers in the K-Cup
Descaling Your Brewer
Depending on the mineral content of your water, calcium deposits or
scale may build up in your brewer. Scale is non-toxic but if left unattended
can hinder brewer performance. Regularly descaling your brewer every
3 to 6 months helps maintain the heating element, and other internal parts
that come in contact with water. Calcium deposits may build up faster,
making it necessary to descale more often.
Before you begin, you will need a large ceramic mug, fresh water,
Keurig Descaling Solution, and access to a sink. Do not use a paper cup.
®
The following outlines the steps required to prepare the brewer before the
descaling procedure:
Unplug the brewer from the power supply.
1.
2. Disconnect or interrupt the external water supply feeding the brewer.
Drain the internal hot and cold water tank (refer to page 17).
3.
Remove the two screws located on the back, top, left of the brewer.
4.
Remove the top cover to gain access to the cold water tank.
Pour the entire bottle of Keurig
5.
Then refill the empty bottle with bottled or filtered water and pour into
the opening.
Reconnect the power supply.
6.
Proceed with the descaling procedure on page 16.
7.
15
pod above the
®
Pod Holder. To avoid risk
®
Pod Assembly Housing.
®
Descaling Solution into the opening.
®