Section 4 Troubleshooting - Keurig Hot K3000SE Manuel D'utilisation

Draining Your Brewer
If you wish to drain the brewer, the following steps should be followed:
Power off the brewer and unplug Power Cord.
1.
Turn the brewer around (shut off water and disconnect power supply if
2.
necessary) so the back is facing you.
Unclip the drain hoses from their holders and lower them. Move the
3.
brewer close to the edge of the counter so that the drain hoses overhang.
Place a container under the hoses and remove the Drain Plugs.
4.
CAUTION: The water may be very hot.
NOTE: The process to completely drain the brewer takes approximately
3 minutes.
When the flow of water stops replace both Drain Plugs and clip the drain
5.
hoses back into place.
When you power up the brewer again it will display "WAS THE BREWER
6.
DRAINED?"
NOTE: Answer "YES" to the question and the brewer will
start "PRIMING."
Storage
Drain the hot water tank before storing and ensure that you store your brewer
in a safe and frost free environment. It is suggested to store your brewer in the
upright position. If you store the brewer in a cold environment, you run the risk
of water freezing inside the brewer and causing damage. When you prepare to
use it after storage, we recommend running three cleansing brews without a
K-Cup pod. If you plan to move your brewer to a different location, turn the
®
brewer off, unplug it and empty both the hot water and cold water tanks. If your
brewer has been in an environment below freezing, please be sure to let it
warm to room temperature for two hours before using.
SECTION 4
SITUATION SOLUTION
Brewer does not • Plug brewer into an independent outlet.
have power • Check to be sure that it is plugged in securely.
• Make sure that the brewer has been turned on and
LCD Display is illuminated.
• Reset circuit breaker if necessary.
• Plug into a different outlet.
Brewer will not • The brewer must be primed for use by filling the
brew when used internal hot water tank before the first brew.
for the first time • If the brewer is cold/frozen, wait for two hours for it to
reach room temperature before powering on.
Brewer will • After placing the K-Cup
not brew Holder, make sure the Handle is lowered completely.
• The Exit Needle may be clogged (refer to page 12).
Brewing a • If the brewer has been set up, without a cleansing
partial cup brew, the first cup may be "oversized" (refer to
page 8). The next cup brewed will be brewed to the
proper selected size.
• The Exit Needle may be clogged (refer to page 12).
• Clean K-Cup
rinse under faucet (refer to page 12).
• If the brewer is alerting you to perform a "DESCALE,"
have your Keurig Authorized Distributor descale the
brewer (refer to page 13).
• If your brewer has been in an environment below
freezing, please be sure to let it warm to room
temperature for two hours before using.
15
Troubleshooting
pod in the K-Cup
®
Pod Holder Assembly if necessary and
®
Pod
®