Seat Height - BH bikes Bolero Pro Manuel D'utilisation

Removing and fitting wheels
Removing: Loosen the brake caliper by releasing or slackening the
brake cable. Pull the release lever from position A to position B. Manually
back off the adjusting nut. Remove the wheel.
Fitting: Insert the wheel axle deep into the slot of the fork end (front
wheel) or of the frame (rear wheel), with the release lever in the 'unlock'
position. Tighten the adjusting nut slightly. Put the release lever in position A.
IMPORTANT NOTE
force. Otherwise, tighten the nut further. If the lever moves with a minimum
manual force, it is not tight enough. Drive the adjusting nut tighter.

Seat height

Ahead stem: To adjust height,
remove the cap and stem, by
loosening the fixing screw and pinch
bolts. Next, insert spacers under or
above the stem as required. Retighten
the stem cap first, until the steering
column turns adequately. Finally,
tighten the pinch bolts.
IMPORTANT
The distance from the top of the stem
or upper spacer to the top of the
steerer must be between 2 and 4mm.
: Locking the lever requires a significant manual
Adjusting
Introduce the seat pillar in the seat
tube. When the seat is at the desired
height, tighten the seat pin or fixing
screw.
WARNING
:
the seat height:
37