Basic Settings - BH bikes Bolero Pro Manuel D'utilisation

o Tyres may be cleaned with a sponge or a brush and soapy water.
o Dry up the bicycle with a cloth or chamois.
o Lubricate the chain drive, after each cleaning process.
IMPORTANT NOTE
avoided. Under no circumstances shall a steam jet be used.

BASIC SETTINGS

Fitting of pedals
Setting of handlebar stem
36
: The use of high-pressure cleaners should be
RHS pedal: The RHS pedal is
identified by letter R marked on its pin.
For mounting the pedal, screw on the
pin clockwise (Fig. A).
LHS pedal: The LHS pedal is
identified by letter L marked on its pin.
For mounting the pedal, screw on the
pin anticlockwise (Fig. B).
Conventional stem: Back off
the stem fixing screw. Tap softly to
unblock the taper ring. Adjust to the
desired height. Retighten the stem
fixing screw.
IMPORTANT WARNING
Check that the minimum inset mark is
not visible.
Adjusting the handlebar position:
Release the handlebar fixing screw.
Turn the handlebar to the desired
angle. Retighten the fixing screw.
: