Tightening Torques For Bolted Joints - BH bikes Bolero Pro Manuel D'utilisation

2. The maximum vertical movement of the bottom bracket axle that the fork,
frame and shock absorber permit.
For your guidance, correct SAG values range from 15% to 35%.
To determine the correct SAG value, refer to the specific suspension
fork and frame shock absorber instructions supplied with the bicycle.

Tightening torques for bolted joints

On assembling any parts, always use the appropriate wrenches and
apply no more than the required hand driving force. Bolts and/or nuts must
be replaced if their threads are found damaged when screwing them on or
off. The following table shows the tightening torques for various screw sizes,
unless otherwise expressly stated.
Testing the braking distance
Before getting on your bike, check both front and rear brakes for perfect
condition. Any cable worn out must be replaced immediately.
It is recommended that both brakes are applied simultaneously, in order
to prevent falls, above all on humid roadways.
The braking distance on a wet surface is approximately 40% longer
than on a dry one.
WARNING!
attached to the handlebars may negatively affect the response time on
braking or turning.
Cleaning
To keep your bicycle in good conditions, take the following elementary
precautions:
o Remove dust and mud with a wet sponge and a soft detergent. Do not
use solvents or very alkaline detergents when cleaning painted parts.
o Plastic components should be cleaned only with soapy water.
The use of streamlining extensions or accessories
35