Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STERILIZATION MODE
1
Fill the container with water, not exceeding the mark «MAX» (280 ml) on
the left side of the device.
1
MAX
280
2
Install the blender bowl, and then insert the steaming basket (9) into the
bowl.
3
Put the bottle in the steaming basket, and then cover it with the measur-
ing cup (7).
4
Activate the sterilizer mode by pressing the button
for this mode is 8 minutes. You can press the buttons
or decrease the sterilization time from 1 minute to 30 minutes.
Then press
operation, press this button again.
After completing the sterilization, the device will beep 6 times.
5
Remove the measuring cup and take out the bottle or other objects using
the tweezers (14).

HEATING MODE

1
Fill the water container*.
*Note: approximately 100 ml of water.
2
Place the blender bowl (6) on the device base, turn it, and then put the
steaming basket (9) into the bowl.
EN
2
to start the device. If you want to suspend the device during
3
4
5
. The default time
to increase
75

Publicité

Table des Matières
loading

Table des Matières