Agu Octopy FP7 Mode D'emploi page 68

INSTALLING THE COVER OF THE BLENDER BOWL
Attach the cover to the blender bowl and turn it counterclockwise so that the cover
locks into place.
INSTALLATION AND REMOVAL OF THE BLADES
1 Insert the gasket (11) onto the blade spindle.
2
Hold the blender bowl (6) upside down and insert the blade spindle into
the hole inside the blender bowl.
3
Place the blade locking ring (12) on the blade spindle, holding the blade in
position inside the bowl (6).
4
Turn the blade locking ring a quarter of a turn counterclockwise to secure
the blade in place.
IMPORTANT
Pull the blade locking ring to check that the blade is correctly screwed in.
68