Accessories; Technical Data - Hilti DD 150-U Mode D'emploi

Conductor cross section
Mains voltage 240 V
Do not use extension cords with 1.25 mm² conductors. Use only extension cords equipped with an earth conductor.
2.8 Using a generator or transformer
en
This machine may be powered by a generator or transformer when the following conditions are fulfilled: The unit must
provide a power output in watts of at least twice the value printed on the type identification plate on the machine. The
operating voltage must remain within +5% and -15% of the rated voltage at all times, frequency must be in the 50 – 60
Hz range and never above 65 Hz, and the unit must be equipped with automatic voltage regulation and starting boost.
NOTE
Switching other machines or appliances on and off can cause undervoltage and/or overvoltage peaks which could
damage the machine. Never operate other machines from the generator/transformer at the same time.

3 Accessories

Designation
TPS theft protection system with
company card, company remote
and TPS‑K key
Water collection system (for use
with the drill stand)
Water collection system (for hand-
guided drilling)
Drill stand (with combination base
plate and tilt mechanism)
Drill stand with anchor base plate
Vacuum base plate
Depth gauge
Hand wheel (lever)
Hand wheel (star handle)
Core bit extension (BI+)
Jack screw
Rota-Rail (column swivel)

4 Technical data

Right of technical changes reserved.
NOTE
The machine is available in various voltage ratings. Please refer to the machine's type identification plate for details of
its rated voltage and rated input power.
Rated
voltage 100
[V]
Rated 15
current
[A]
28
1.5 mm²
40 m
Short designation
DD-ST-120/160-VBP
110 GB 110 TW
16 15
2.5 mm² 3.5 mm²
70 m Not recommen-
ded
Description
Option
120 127
19.5 18.5
4.0 mm²
110 m
220 230
10 10.3
240
9.9