Installing Your Thermostat; Positioning The Room Thermostat; Technical Specifications Of The Room Thermostat; Installation - Acova Z23010-03 Notice D'utilisation

EN

3. Installing your thermostat

3.1 Positioning the room thermostat

For effective control of your appliance, the thermostat must be able to measure
the most representative ambient temperature in your room.
To ensure that the infrared signal is correctly received, the thermostat must be
located in the same room as your towel radiator. It must be no more than 10 m away
from the radiator in direct line of sight uninterrupted by any obstacle (wall, furniture,
etc.).
Under certain conditions, the signal can be reflected off smooth shiny surfaces
(such as tiles).
Before installing the thermostat permanently, check for objects likely to disrupt
signals between the transmitter and the receiver on the towel radiator, and carry out an
infrared signal test (see section 6.3).
The temperature sensor is located inside the room thermostat unit. Therefore,
the room thermostat should be:
- mounted on a wall or placed on a shelf or an accessible piece of furniture at a
height of approximately 1.50 m
- protected from sources of heat (light, sunlight, etc.) and draughts (windows,
doors, fans)
- and should not be placed on an exterior wall or a wall adjoining an unheated
room (garage etc.).
Wall mounted
Approximate
height
1.50 m
20 cm min
34
On a piece
of furniture

3.2 Technical specifications of the room thermostat

- Powered by 2x1.5 V alkaline batteries, type LR03 or AAA (supplied), battery
life over 2 years under normal use.
- Remote control device with a free-field infrared signal range of 10 metres and
50° beam angle.
- Operating temperature: 0°C to +40°C.

3.3 Installation

The thermostat can either be stood on the stand supplied or mounted on a wall.

3.3.1 Wall mounting

Remove the cover using a screwdriver (A ). Re-
move the batteries supplied with the device.
Secure the thermostat to the wall using screws and
wall plugs or place in an electrical mounting box (B: centre to
centre distance 60 mm).
Replace the batteries, ensuring the correct polarity.
For a first use, remove the battery insulation tab (see
chapter 5.2).

3.3.2 Using the stand

You can place the transmitter on a piece of furniture using
the stand supplied.
Z23010-03 Z23010-03
EN
A
+ -
- +
B
1
2
35