Acova Z23010-03 Notice D'utilisation page 21

EN
Turn the dial to:
to set the frost protection temperature
(between 5°C and 15°C)
to set the economy temperature
(between 10°C and 30°C)
to set the comfort temperature
(between 10°C and 30°C)
Press + or - to change the temperature in 0.5°C increments. Then turn the dial
to move to the next setting.
NOTE You can change what temperature (set point or room) is displayed for
about 3 seconds by pressing the i button:
– In automatic mode the room temperature is displayed by default, pressing the i
button will temporarily show the set point temperature;
– in COMFORT, ECO and FROST PROTECTION mode the set point is displayed
by default, pressing the i button will temporarily show the room temperature.
If you wish to deviate from the program (see chapter 5.4.2), you can switch to
permanent eco mode ( ), permanent comfort mode (
tion mode ( ) by turning the dial to the desired mode.
5.4.2 Programming the thermostat
The program function is used to schedule operation of the ECO (
FORT ( ) modes throughout the day.
The thermostat can be set to operate to the same program every day (daily
program) or to a different program each day (weekly program).
You can also switch your appliance to any desired mode (
manually using the dial at any time if your schedule changes.
DEFAULT PROGRAM
To view the program, turn the dial to PROG.
On first use, the programmable thermostat is set to run the program "COM-
FORT from 6am to 11pm" every day of the week.
40
Setpoint temperature
) or permanent frost protec-
) and COM-
or or )
Z23010-03
Start of timeslot displayed
Move to next day
Default program profile:
– from midnight to 6am: ECO mode
– from 6am to 11pm: COMFORT mode
– from 11pm to midnight: ECO mode
CUSTOM PROGRAM
To change the program, turn the dial to PROG.
The screen shows the program for day 1 (for example Monday).
against the day being programmed.
– When the first timeslot (from midnight to 1am) blinks, press
COMFORT mode or to select ECO mode.
– You will move to the next timeslot automatically. Repeat until you have ente-
red settings for the entire day.
– If you wish to make any corrections, cycle through all the timeslots until you
reach the one you want to change.
– When you are ready, press OK to confirm your settings for the day and move
to the next day.
NOTE To apply the same program for the following day, keep the OK button pressed
down for approximately 3 seconds until the program for the following day is displayed.
Start of timeslot you
are modifying
First timeslot
Select Economy for 1h
Select Comfort for 1h
Move to next day
Z23010-03
EN
Day displayed
Program profile for day
displayed
Go to next program change
is displayed
to select
Day you are modifying
Program profile for the
day you are modifying
Go to next program change
41