Infrared Signal Test; Restoring The Factory Settings; Maintenance And Troubleshooting; Routine Maintenance Operations - Acova Z23010-03 Notice D'utilisation

EN
6.3 Infrared signal test (CF03)
The thermostat sends an infrared signal to the recei-
ver on your appliance every 3 seconds. The
appear briefly.
The light on the receiver should blink each time it
does so, confirming that the signal has been received.
To exit the advanced settings function, turn the dial.

6.4 Restoring the factory settings

Restarting the thermostat will restore the following
values to their factory settings:
- the advanced settings (shaded in the CF menus),
- the time and day,
- the setpoint temperatures,
- the default program values.
Turn the dial to NO HEAT
button for 10 seconds until INIT is displayed.
Press OK to confirm or C to cancel. The NO HEAT
mode display will then reappear.
46
symbol will
and press the leftmost
10 sec.
7. Maintenance and troubleshooting tips

7.1 Routine maintenance operations

High-quality materials and surface treatment protect your appliance against
corrosion and impacts.
To maximise the service life of your appliance, we recommend you take the
following precautions:
- Never use abrasive or corrosive products on the outer surfaces of the
appliance; use warm, soapy water.
- Use a soft dry cloth (without solvent) to clean the power supply unit and the
room thermostat.

7.2 Heating test

To perform a heating test, turn the thermostat dial to COMFORT (
enter a setpoint temperature that is higher than the room temperature: the flame icon
( ) should be displayed and after a few minutes you should be able to feel the radiator
heating up.
If the radiator remains cold, check the batteries (see chapter 5.2) and the posi-
tion of the room thermostat (see chapter 3.1) and perform an infrared signal test (see
chapter 6.3).
If your towel radiator stops receiving instructions from the room thermostat for
any reason (batteries flat, transmitter obstructed, etc.) it will switch off 20 minutes after
the last signal is received and the indicator light on the receiver will blink until the fault
is rectified.

7.3 Troubleshooting

If your appliance stops working, check that:
Z23010-03 Z23010-03
EN
) mode and
47