Advanced Functions; Adjusting The Room Temperature Measurement; Selecting The Temperature Displayed In Auto Mode - Acova Z23010-03 Notice D'utilisation

EN
MANUAL BOOST
Pressing the button will cause the appliance to heat
continuously for an adjustable period of between 30 minutes
and 4 hours (boost).
When in automatic mode (AUTO), press the
The manual mode duration will blink. Press + or - to
increase or decrease the desired duration in 30 minute incre-
ments. Press OK to confirm.
The time remaining will scroll across the display.
Press the C button to exit manual mode at any time.
5.4.4 No Heat mode
To put the radiator into NO HEAT mode (in summer,
for example), turn the dial to . The thermostat will display
the measured room temperature.
44
button.
Manual mode active
No Heat
Room temperature
Z23010-03
6. Advanced functions (for advanced
users)
Turn the dial to NO HEAT
button for 5 seconds until the screen displays H600 x:xx
(remote control model number).
Press OK. The screen will display CF01.

6.1 Adjusting the room temperature measurement

(CF01)
If the room temperature measured by the thermostat
deviates from actual room temperature, the thermostat mea-
surement can be adjusted by up to +/- 4°C by pressing the
+ and - buttons.
Press + or - to select the desired value then press OK
to confirm and move to the next menu.

6.2 Selecting the temperature displayed in Auto mode

(CF02)
Using this function you can choose to display either
the room temperature measured by your thermostat or the
setpoint temperature. Press + or - to select the desired value
then press OK to confirm and move to the next menu.
0: room temperature always displayed
1: setpoint temperature always displayed
Z23010-03
and press the rightmost
5 sec.
EN
45