Checking Oil Level - Powerbuilt Ujack 620516 Manuel D'utilisation Et D'entretien

4000 lbs / 1814 kg
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Lowering Vehicle:
1. Align U-Jack™ front wheels with jack stand base.
2. Turn the handle clockwise to closed position. Do not over tighten!
3. Align saddle with jack point.
4. Raise the vehicle off jack stand by pumping the handle.
5. Working from side of car carefully lower jack stand column and remove jack stand.
6. Slowly lower U-Jack™ by turning release valve counter clockwise until vehicle is on ground.
1
The product shall be maintained in accordance with the product instructions. No alterations shall be made to this product.
1. Before each use, a visual inspection of the jack shall be made for abnormal conditions such as cracked welds, damaged,
bent, worn, loose or missing parts, or hydraulic leaks.
2. Inspections shall be performed in accordance with this manual.
3. The product shall be inspected immediately if the jack is believed to have been subjected to an abnormal load or shock. It
is recommended that this inspection be made by an authorized customer service representative prior to use.
4. Repair of this equipment requires specialized knowledge and facilities. If the jack is subjected to abnormal load or shock,
remove from service and have it examined by an authorized inspection repair facility. Any defective parts, decals, or safety
labels shall be replaced with manufacturer's specified parts. If you encounter any problems or difficulties, please do not
return this jack to the store. Please contact our toll free customer service department at 1-800-423-3598.
5. Attachments and Adapters. Only attachments and/or adapters supplied by the manufacturer shall be used.
Always store your jack in the fully lowered position. This will prevent critical areas from excessive corrosion.
Do not use brake or transmission fluids, or regular motor oil as they can damage the seals. Always purchase and use products
labeled Hydraulic Jack Oil.
1. Turn handle counterclockwise to allow ram to fully retract. It may be necessary to apply force to the saddle for lowering.
2. With jack in upright position remove oil fill plug. Oil should be even with bottom of hole. If not, top up.
Do not overfill. Always fill with new, clean hydraulic jack oil.
3. Replace fill plug.
4. Check jack operation.
At this time, consult Troubleshooting section for System Air Purge.
1. Owners and/or operators should be aware that repair of this equipment may require special knowledge and facilities.
2. It is recommended that an annual inspection of the jack be made and that any defective parts, decals, or safety labels or
signs be replace with manufacturer's specified parts.
3. Any jack that appears to be damaged in anyway, is found to be worn, or operates abnormally shall be removed from service
until repaired.
4. Because of the potential hazards associated with this type of equipment, no alterations shall be made to this product.
5. Do not mix different types of oil together. When filling the jack with oil, do not permit dirt or any other substance to enter
the hydraulic system.
OPERATIONS
2
INSPECTION
JACK STORAGE

CHECKING OIL LEVEL

!!WARNING!!
MAINTENANCE
4
3

Publicité

Table des Matières
loading

Table des Matières