Powerbuilt Ujack 620516 Manuel D'utilisation Et D'entretien page 2

FAILURE TO OBEY THESE WARNINGS MAY RESULT IN LOSS OF LOAD, DAMAGE TO JACK,
AND OR JACK FAILURE RESULTING IN PERSONAL INJURY OR PROPERTY DAMAGE.
• STUDY, UNDERSTAND, AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING THIS DEVICE.
• DO NOT EXCEED RATED CAPACITY.
• USE WHEEL CHOCKS ON THE WHEELS OF THE AXLE NOT BEING RAISED.
• USE ONLY ON HARD LEVEL SURFACE.
• SUPPORT THE VEHICLE WITH APPROPRAITE MEANS IMMEDIATELY AFTER LIFTING.
• LIFT ONLY ON AREAS OF THE VEHICLE AS SPECIFIED BY THE VEHICLE MANUFACTURER.
• PLACE LOAD IN CENTER OF THE SADDLE ONLY. LOAD SADDLES EQUALLY TO PREVENT TIPPING.
• DO NOT MOVE OR DOLLY THE VEHICLE WHILE ON THE JACK.
• USE JACK STANDS IN MATCHED PAIRS ONLY
• MAXIMUM LOAD CAPACITY PER MATCHED PAIR OF JACK STANDS SHALL NOT EXCEED THE RATED CAPACITY OF
THE INDIVIDUAL STAND
• USE STANDS TO SUPPORT ONE END OF THE VEHICLE ONLY
• DO NOT USE LIFT ON ROUNDED VEHICLE SURFACES
• KEEP CHILDREN AWAY FROM WORK AREA.
• ONLY ATTACHMENTS AND/OR ADAPTERS SUPPLIED BY THE MANUFACTURER SHALL BE USED.
• NO ALTERATION SHALL BE MADE TO THIS PRODUCT.
• FAILURE TO HEED THESE WARNINGS MAY RESULT IN PERSONAL INJURY AND/ OR PROPERTY DAMAGE.
P R N D 1 2
Your jack has been shipped with a retaining hook to hold the yoke in the downward position. This must be removed.
CAUTION: YOKE IS UNDER SPRING PRESSURE AND COULD POP UP AND CAUSE PERSONAL OR PROPERTY DAMAGE. WEAR EYE
PROTECTION AND GLOVES TO REMOVE YOKE RETAINING HOOK. Push down on the yoke until the retaining hook can be removed from
between the yoke and pull rod. A second person may be needed to hold the front of the jack down while applying downward force to the yoke.
Remove the retaining hook and allow the yoke to raise to it's upper resting position.
Retaining Hook
Yoke
IMPORTANT SAFETY INFORMATION.
READ ALL SAFETY WARNINGS BEFORE OPERATION!
YOKE RETAINING HOOK REMOVAL
Press Down
U-JACK™
ASSEMBLY
1. Slide the lower handle into the upper handle, depress the locking button, and
slide into the bottom section until button snaps into hole.
2. Loosen the handle socket screw in the yoke.
3. Apply a small amount of grease to the handle socket.
4. Place the assembled handle into the handle socket.
5. Tighten the handle socket screw.
2