Horizon Hobby HobbyZone AeroScout Manuel D'utilisation page 8

EN
Assemble and install the wing
1. Slide the carbon fi ber wing spar fully into a wing panel as shown. Ensure
the aileron servo lead exits through the slot in the bottom of the wing.
2. Slide the opposite wing panel over the wing spar until the root of the wing
panels are tight and the rear mounting hole is correctly aligned. Ensure
both aileron servo leads exit through the bottom of the wing and are not
pinched between the wing panels.
3. Connect the aileron servo leads to the y-harness installed in channel 2 of
the receiver.
4. Center the wing on the fuselage. Ensure the aileron leads are not pinched
between the wing and fuselage.
5. Attach the wing with the included 50mm screws. Do not overtighten the
wing screws, as it may damage the wing or the attachment points in the
fuselage.
IMPORTANT: The wing screws may be a tight fi t the fi rst few times they are
installed into the fuselage. Use a screwdriver if necessary until the fuselage
attachment points loosen up enough for the screws to be installed by hand.
NOTICE: Do not overtighten the wing screws. Doing so will crush the foam of
the wing or damage the fuselage attachment points.
®
8