Assemble The Aircraft - Horizon Hobby HobbyZone AeroScout Manuel D'utilisation

Assemble the Aircraft

Install the landing gear
1. Slide the main gear into the slots in the fuselage until they lock into place.
2. Insert the nose gear into the wheel collar as shown and tighten the
setscrew against the fl at in the gear wire using a phillips screwdriver.
Install the horizontal tail
1. Slide the longer of the two included square carbon fi ber tubes fully into the
hole of either of the horizontal stabilizers. The tube is a compression fi t and
does not require any adhesive.
2. Insert the tube through the hole in the vertical tail of the fuselage as shown,
until the previously attached horizontal stabilizer is against the fuselage.
IMPORTANT: The decals on the horizontal stabilizers must face up when the
stabilizers are installed correctly.
3. Slide the opposite horizontal stabilizer over the other end of the tube. Press
the stabilizer halves together until they are both fully seated on the tube
and there is just a small gap between the stabilizers and the fuselage.
7
EN
AeroScout S