SSS Siedle Confort HTC 811-0 Notice D'utilisation page 3

English
Accepting door calls
The ringing tones for the front
door, apartment door and internal
telephony are different. When a
visitor presses the door bell, the in-
house telephone rings. The call
can be accepted within 30 seconds
of the last ring tone.
Actuating the door release
When you press the door release
button, the door from which the
last call came is opened for 3
seconds.
Switching on the light
When you press the light button,
the lighting is switched on,
provided this has been connected
by your electrical installer.
Setting the ring tone volume
The rotary controller is able to
regulate the ring tone volume from
very quiet to maximum volume. If
the rotary controller is turned past
a slight resistance point, the ring
tone is muted.
It is not possible to change the
speech volume of the receiver or
the call tone melody.
Control functions
With the receiver down, the free
buttons can be used to carry out
various switching and control
functions; e.g. light switch.
The functions depend on how the
installation has been performed by
your electrical installer.
Internal calls
Lift the receiver and press one of
the buttons in order to call internal
users. Use the lettering panel to
inscribe the relevant name.
Additional installation required.
Illuminated display
Depending on the installation,
there are two buttons which can
light up yellow.
It is possible to use these to
indicate e.g. an open front door
or light switched on. For more
detailed information, please
contact your electrical installer.
Care of your phone
Only ever clean your telephone
using a soft cloth dampened with
mild soap solution. Dry cleaning,
aggressive cleaning agents and
abrasives can damage the surface.
Servicing
Statutory warranty conditions
apply. Exchange of the device in
case of servicing must be
performed by your electrical
installer.
3