Whirlpool WRT771RWYM Instructions D'utilisation page 11

Touch any control button on the dispenser panel to activate
the display screen.
Adjusting the Controls
For your convenience, the temperature control is preset at the
factory. When you first install your refrigerator, make sure that the
control is still set to the recommended temperature setting
(3 snowflakes), as shown.
If you need to adjust the temperature in either the refrigerator or
freezer compartment, use the settings listed in the following chart
as a guide.
Wait at least 24 hours between adjustments. Recheck the
temperatures before other adjustments are made. The single
temperature control ranges from 1 snowflake (least cold) to 5
snowflakes (coldest). When adjusting temperature set points,
use the following chart as a guide.
CONDITION:
REFRIGERATOR or FREEZER
too cold
REFRIGERATOR or FREEZER
too warm
Cooling On/Off
Your refrigerator and freezer will not cool when cooling is
turned off.
To turn cooling off, press and hold both TEMPERATURE
buttons at the same time for 3 seconds. When cooling is off,
"Cooling Off" will appear on the display screen.
TEMPERATURE
ADJUSTMENT:
Press the left-hand
TEMPERATURE button to
adjust the temperature
one setting
less cold (2 snowflakes)
Press the right-hand
TEMPERATURE button to
adjust the temperature
one setting
colder (4 snowflakes)
To turn cooling back on. Press and hold both TEMPERATURE
buttons at the same time for 3 seconds. When cooling is on,
"Cooling Off" will disappear from the display screen.
Additional Features
Door Open Alarm
The Door Open icon lights up whenever either door is opened.
When either door is open for 5 minutes and cooling is on, an
alert tone will sound three times, and the Door Open icon will
flash seven times. This pattern will repeat every 2 minutes until
all the doors are closed properly. The feature then resets and
will reactivate when either door is left open again for
5 minutes.
NOTES:
To mute the audible alarm while keeping the doors open, such
as while cleaning the inside of the refrigerator, press any
button on the control panel. The alarm sound will be
temporarily turned off, but the Door Open icon will still be
displayed on the dispenser control panel.
Both doors must be fully closed to turn off the Door Open
icon.
Fast Cool
The fast cool feature assists during times of high refrigerator use,
full grocery loads or temporarily warm room temperatures.
Press FAST COOL to set the freezer and refrigerator to the
coldest temperature settings. Press FAST COOL again to
return to the selected temperature set point.
NOTES:
The Fast Cool icon will be illuminated while the refrigerator
is in Fast Cool mode.
The Fast Cool feature will turn off automatically after
24 hours.
Water Filter Status Light and Reset
The filter reset control allows you to restart the water filter status
tracking feature each time you replace the water filter. See "Water
Filtration System."
Press and hold WATER FILTER for 3 seconds, to reset the
water filter status to Good. The water filter LED will turn blue.
Air Filter Status Light and Reset
The filter reset control allows you to restart the water filter status
tracking feature each time you replace the water filter. See "Install
Air Filter."
Press and hold AIR FILTER for 3 seconds, to reset the air filter
status to Good. The air filter LED will turn blue.
11