Electrical Connections - THORENS TD 1600 Manuel D'utilisation

Electrical connections

To power the turntable, connect the 16V output
of the power supply (Figure 12) to the input on
the right side of the terminal on the back of the
TD 1600 / TD 1601 using the enclosed cable
(Figure 13). The plugs should be locked in place
for safe operation with the knurled nuts.
The mains voltage can be switched depending
on the country at the bottom of the power supply
by a switch between 115V / 60 Hz and 230V / 50
Hz (Fig. 14).
Warning: before starting operation make sure
that the mains frequency and voltage are set
correctly. Otherwise there is a risk of damage
to the device.
Only then do connect the power supply to the
mains power socket with the included power
cable.
Below the connector on the back of the power
supply is the main electrical switch which turns
the power to the unit on and off. When the switch
is in position 0, the unit is completely disconnect-
ed from the mains.
35 ELECTRICAL CONNECTIONS
Fig. 12
Fig. 13
Fig. 14