Sony SU-SX10 Mode D'emploi page 3

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Note on load capacity
Do not place any equipment exceeding the specified
maximum weight on the stand, as indicated in the
illustration bellow. Otherwise, it may fall or break.
125 kg (275 lb 9 oz)
58 kg (127 lb 14 oz)
Notes on installation
• Be careful not to pinch your hand or fingers between
the TV and the stand.
• Be careful not to pinch your fingers when attaching
the top front cover after placing the TV on the stand.
• To prevent the stand from distorting, observe the
following:
– Install the stand on a solid and flat surface.
– If you install the stand on a soft surface such as a
mat, first lay a board under the stand.
– Do not install the stand in a place subject to direct
sunlight or near a heater.
– Do not install the stand in a hot or humid place,
or outdoors.
• Moving the stand requires four people or more.
Move the stand only after removing the TV. If you
fail to do so, the TV may fall from the stand resulting
in serious injury. Do not hold the top front cover as it
may detach from the stand resulting in serious
injury.
Notes on use
• Do not place any heated objects on the stand. If you
do so, the stand may discolor or distort.
• To keep the stand clean, occasionally wipe the stand
gently with a dry, soft cloth. Stubborn stains may be
removed with a cloth slightly dampened with
diluted detergent, followed by a soft dry cloth. Do
not use any type of chemicals, such as thinner or
benzine, as they may damage the finish of the stand.
• When placing the top front cover on the floor after
removing it from the stand, cover the floor with a
cloth, etc., beforehand to protect the floor from
damage.
When moving the TV stand
This TV stand can be moved in the directions indicated
by the arrows but cannot be moved to the right or left.
If you try to move the TV stand forcibly, the stand may
damage the floor or topple over.
If you want to move the stand to the right or left
Pull the stand forward once 1, and then push it back
2 to the appropriate position.
2
Notes
• Hold the side panel or bottom panel when moving
the stand. If you try to move the stand forcibly, the
stand may topple over and cause injury.
• When moving the stand over an uneven floor,
release the support belt and uninstall the TV from
the stand.
• Be careful not to allow your hand or feet to be
pinched under the bottom plate or run over by the
casters.
• Do not hold the stand by the top front cover as it
may detach from the stand resulting in serious
injury.
2
1
3
(US)
US

Publicité

Table des Matières
loading

Table des Matières