Basic Operation; Icon Descriptions - Timex Cycle Trainer 2.0 Manuel D'utilisation

basIC operaTIon

baCK/
baCK/
Hold for 2 seconds to turn the Cycle Trainer 2.0
go back to the previous page.
/enTer
Press to cycle through screens in Speedometer mode. Hold to enter the main menus. In menus, press to select
the highlighted choice.
/sTarT/sTop
Press to highlight the previous item in a list. Press to start or stop the timer in Speedometer mode. Press to
zoom out in Map mode.
lap/reseT/
Press to highlight the next item in a list. While timer is running in Speedometer mode, press to start a new lap.
While timer is stopped in Speedometer mode, press to save the ride and clear the timer.

ICon desCrIpTIons

These icons can appear on the Time and menu screens.
GPS status
Timer
Cadence
sensor
Alarm
Heart rate
sensor
Battery
/enTer
on or off. Press to turn on the night-light. In menus, press to
™
solid: GPS has a satellite fix. More bars indicate a stronger signal.
blinking: GPS is seeking a satellite fix.
solid: Timer is running.
blinking: Timer is stopped, but has not been reset.
solid: Device is receiving data from a cadence sensor.
blinking: Device is searching for a cadence sensor.
An alarm is set and will sound at the specified time.
solid: Device is receiving data from a heart rate sensor.
blinking: Device is searching for a heart rate sensor.
Indicates the remaining battery power. More lit segments indicate a higher charge.
/sTarT/sTop
lap/reseT/
5