Configuring Data Recording Options; Configuring Custom Pages - Timex Cycle Trainer 2.0 Manuel D'utilisation

seTTIng a CusTom Zone
If you chose CUSTOM in step 5, you must set the maximum and minimum values for an acceptable power
reading.
1. Highlight the HIGH POWER ALERT field, then press ENTER.
2. Highlight ON, then press ENTER.
3. Highlight the ABOVE field, then press ENTER.
4. Press  or  to change numbers, then press ENTER.
5. Repeat steps 1-4 for the LOW POWER ALERT and BELOW fields.
ChoosIng a poWer Zone
If you chose POWER ZONE in step 5, you must select which power zone you want to stay within.
1. Highlight the ZONE field, then press ENTER.
2. Highlight the zone you want to stay within, then press ENTER.
The maximum and minimum values now match those configured for the power sensor.
alert meSSageS
Choose whether to display Alert messages as symbols or full text.
If you choose MESSAGE/BEEPER, full text of the message displays. For example, if you speed is too low, a GO
FASTER! message displays.
If you choose SYMBOL/BEEPER, an exclamation point displays when the Alert sounds, but no additional
information is given.
1. From the ACTIVITY menu, highlight SETTING, then press ENTER.
2. Highlight ALERTS, then press ENTER.
3. Highlight SETTING, then press ENTER.
4. Highlight the ALERTS field, then press ENTER.
5. Press  or  to choose MESSAGE/BEEPER or SYMBOL/BEEPER, then press ENTER.

ConfIgurIng daTa reCordIng opTIons

Choose how often data will be recorded from the GPS and other sensors during a ride. More frequent
recordings give more accurate readings, but take up more memory in the Cycle Trainer.
Also choose whether the Cycle Trainer uses the GPS or the barometer to find altitude.
1. From the ACTIVITY menu, highlight SETTING, then press ENTER.
2. Highlight DATA RECORD, then press ENTER.
3. Highlight the RECORD DATA POINTS field, then press ENTER.
4. Press  or  to choose EVERY SECOND or CUSTOM TIME, then press ENTER.
5. If you chose CUSTOM TIME, highlight the RECORD EVERY field, then press ENTER.
6. Press  or  to select the number of seconds between each recording, then press ENTER.
7. Highlight ALTITUDE SET, then press ENTER.
8. Highlight FROM GPS or BAROMETER, then press ENTER.

ConfIgurIng CusTom pages

There are 4 custom pages that can display in Speedometer mode. Each of these custom screens can have
between 2 and 6 fields that each display different data. Some of this data is recorded when you reset and
save a ride, but some are only visible in Speedometer mode or if you upload your ride to Training Peaks.
20