ROSIERES RHP90TX Manuel D'utilisation page 9

2. Press the button "Speed" time after time, the motor runs as low / mid / high / low /
mid..., the speed runs circularly; and the LED display will indicate as 1-2-3-1-2...
circularly.
3. Press "Light" button, the light is on, press this button again, the light is off, keep
pressing this button, the lights are on/off circularly. Please note the Lamp is not under
control of the on/off button.
4. When the hood is working, if press the "Timer" button, the hood will go into the
status of acquiescent working (acquiescent time is 9mins), and then, LED display will
be shown 9.8.7.6 ...decreasing by 1,when time is up, the hood will be off automatically
and the lamp will extinguish. If pressing "Timer" button, the hood will go in or go out
"Timer" function.
TROUBLESHOOTING
Fault
Light on, but
motor does not
work
Light does not
work, motor does
not work
Oil leakage
Lights not
working
Insufficient
suction
The Cooker hood
inclines
Possible Cause
Fan switch turned off
Fan switch failed
Motor failed
House fuses blown
Power cord loose or
disconnected
One way valve and the outlet
are not tightly sealed
Leakage from the connection
of chimney and cover
Broken/Faulty globes
The distance between the
cooker hood and the gas top
is too far
The fixing screw not tight
enough
Select a fan switch position.
Contact service center.
Contact service center.
Reset/Replace fuses.
Refit cord to power outlet.
Switch power outlet on.
Take down the one way valve
and seal with sealant.
Take chimney down and seal.
Replace globes as per this
instruction.
Refit the cooker hood to the
correct distance.
Tighten the hanging screw
and make it horizontal.
8
Solution