Installation Instructions - Siemens HQ74552.E Manuel D'installation Et D'utilisation

The appliance is in class 1 or class 2
subclass 1
Instructions for the installer
The appliance shall be fitted with a stability
device secured to the fabric of the building,
conforming to local regulations.
Stability device installation
After having connected the appliance to the
gas mains, attach the safety chain to the
rigid pipe section by means of the round
fixing supplied with the chain.
Then secure the other end of the chain to
the rear wall.
The following notes are intended for the
approved gas or electrical appliance fitters
so that they are able to install, adjust and
technically maintain the appliances in
accordance with current regulations and
standards.
Important: The cooker must be disconnected
from the mains before any adjustment or
maintenance work is carried out.
For the appliance technical features, refer
to the rating plate stiked on the inside of the
front appliance drawer.
Fig. 9
OK

Installation instructions

Fig. 8
NO
Securing the cooker to the wall
Drill two holes in the wall approximately
710 mm above the lower edge of the sides
of the cooker (as shown in fig. A position F,
so that they are concealed by the cooker
itself (see fig. B). Insert part R (rawlplug) into
holes F and screw hook G in part R (fig. C).
Secure the chain to hook G as shown in fig.
D position C.
Fig. A
Position F
= hole
ø 6 mm
60 mm +/- 3
H -
adjustable
foot
Fig. C
G R
39
Fig. B
Position
2
G
Fig. D
wall
position C
F
GB
Position
1
wall