Cleaning; Storage; Disposal; Troubleshooting - Zipper Maschinen ZI-BTS350 Mode D'emploi

14.3

Cleaning

Cleaning: The use of paint thinners, gasoline, corrosive chemicals or abrasive cleaners
will result in damage to the surface!
Therefore:
14.4

Storage

If the machine more than a month is not used, please follow these instructions:

Entire remove fuel from the tank, fuel cock and carburetor.

Water from the tap and remove line (this is to do in cold weather after each use)

Remove spark plug, pour about 1 tablespoon of engine oil into spark plug hole

Engine switch to the OFF

Operate starter rope several times

Spark plug insert

Generator in a dry, well ventilated place, cover.

14.5 Disposal

Do not dispose of your waste in the ZI-BTS350. Contact your local authorities for
information regarding the available disposal options. Improper disposal can lead to
contamination of soil, ground water soil seepage of hazardous and noxious substances,
and thus reach finally through contaminated water into your food supply and your
health. Replace your old unit with a new one at your local dealer, is obligated to take
back your old equipment free of charge for the purpose of proper disposal.
15

TROUBLESHOOTING

Trouble
Engine will not start
Engine stops after
starting
Less engine power
Bade does not run
Blade runs bad
ZIPPER MASCHINEN GmbH
ZI-BTS350
When cleaning, use only mild detergent
Possible Cause

ON OFF switch to OFF

Fuel filter clogged

Great power tank empty

Spark plug is defective or loose

Spark plug gap set wrong

Idle speed too low

Clogged fuel filter

The fuel tank is empty

Dirty air filter

V-belt is defective

defective clutch

cutting wheel shaft
www.Zipper-Maschinen.at
N O T E












flange and nut.

TROUBLESHOOTING
Solution
Switch in the On position
Fuel filter change
Fill the fuel tank
Clean or replace spark plug
Check the correct setting
Adjust idle speed
Change the fuel filter
add fuel
Clean or replace air filter
Change belts
machine repair
Check ball bearings, shaft,
Replace if defective
26