Table des Matières
Publicité
11
SAFETY
11.1
Intended Use
The ZIPPER ZI-BTS350 is approved for the following stated activities in compliance with the safety
instructions described in this operating and maintenance instructions:
Asphalt and concrete cutting in compliance with all technical limits and all safety regulations.
The improper use or failure to comply with the provisions and instructions detailed in this manual
will void all claims for damages against the ZIPPER GmbH result.
Unauthorized modifications and manipulations of the machine also immediately invalidate all
warranty and damage claims.
11.2
Safety
Warning signs and / or labels on the machine that are illegible or have been removed are to be
replaced immediately!
The most important factor for adequate security at work is common sense. Care and good judgment
are the best protection against injury. This list of general safety information does not purport to
include all possible sources of danger, but we have tried to highlight some of the important details.
Individuals should look for caution, warning and danger signs that are marked on the device and
displayed at work and read the safety, understand and heed.
ZIPPER MASCHINEN GmbH
ZI-BTS350
During refueling the fire, naked flame and smoking prohibited.
Refuel with the engine running or when engine parts are still hot, is strictly
prohibited.
Refuel only outdoors or in well-ventilated areas.
Wipe off spilled fuel immediately.
Fuel is highly flammable!
With fatigue, lack of concentration or under the influence of medicines, alcohol
or drugs that work on the machine is prohibited!
Before each use, check machine in perfect condition! Oil level, blade condition,
tightness screws etc ...
The regular maintenance and inspection is safety critical.
The machine may only be operated by qualified personnel enrolled.
Unauthorized persons, especially children, and people are not trained to keep
away from the machine! Operation of the machine just over 18 years.
If you work on the machine, you do not wear loose jewelry, loose clothing,
ties, long, loose hair, etc ...
Loose objects can become entangled in moving parts of the machine and cause
injury!
When working on the machine zertifizerte appropriate protective equipment
(gloves, work shoes with steel inserts, safety glasses, hearing protection, ...)
wear!
Engine emissions contain toxic gases, which have a negative impact on
personal health. Therefore, they work with the machine in a well ventilated
area or outdoors!
NEVER touch the carburetor, spark plug, air filter. Motor unit during and
immediately after the operation! Risk of burns!
Allow the engine to cool before adding fuel perform maintenance etc. ...
The running machine should never be left unattended! Turn off the machine
before leaving the work area and wait until the engine is at a standstill!
www.Zipper-Maschinen.at
SAFETY
20
Publicité
Table des Matières
Dépannage
