Water Supply; Maintenance; Maintenance Activities; Spark Plug (Every 50H) - Zipper Maschinen ZI-BTS350 Mode D'emploi

13.1.4 Water supply

The water connection, you can connect a water supply.
This allows you to achieve a uniform cooling of the blade and reduce the formation of dust
strongly.
Operation

Review safe working environment, safe work clothing, machine before putting on faultless
and operational condition.

Saw at Max. , align top position, fold down section markers (linkage with red roller) to cut
line. Align the saw blade to cut line.

gate valve at the bottom of the water tank open.

Start the engine

blade wind down slowly deepen the cut until the desired depth of cut is reached.

Cut only as fast as it allows the material. If the blade lifts the feed, you slow down the feed!

If desired cutting depth of more than 90mm, this should be achieved through two steps.

The proper sense of the proper feed speed is important. Please slide the machine fast enough
that the blade can work into the material, but once they realize that the speed decreases,
reduce the feed.

No lateral pressure on the blade.

Can not operate without blade guard mounted!

Do not force the blade into the material. Let the wheel going into the material alone.

Do not perform long continuous cuts.

No Dry cutting saw blades are suitable for wet cutting.

No curves intersect. Not inclined to fix blade material.
14

MAINTENANCE

14.1

Maintenance activities

 Check the belt tension and adjust as required
 Lubricate the bearings of the diamond saw blade axis daily
 Before each use, the blade is in good condition and tight fit
 Before each use the air filter is clean.
 Before each use screw connections for tightness
 Air filter (every 100 hours)
1. Remove the air filter.
2. Clean it in a solution.
3. Drops of engine oil on the air filter.
4. Waste engine oil to remove from the air filter by wring it out.
CAUTION: NEVER WITHOUT ENGINE AIR FILTER OR
MAINTAINTED AIR FILTER WITH NOT OPERATE
14.2

Spark plug (every 50h)


Remove the spark plug contact.

Remove any debris with a brush.

Inspect the spark plug for discoloration.

Check the contact gap. Standard: 0.7 ~ 0.8mm
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BTS350
MAINTENANCE
25