Internal Light; Cleaning, Care & Maintenance - Polar Refrigeration CM287 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
UK
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
To avoid higher energy consumption and a shorter
compressor life, your refrigerated equipment
should never be installed:
Near sources of heat such as radiators, direct
or indirect sunlight or other equipment which
produce heat.
In line with draughts coming from doors,
windows or air-conditioning systems.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
Operation
Control Panel
Refrigerant LED
A
A - Power Switch
B - Controller
4
CM287_ML_A5_v4_20190730.indb 4
Defrost LED
B
Turn On
1. Ensure the power switch A is set to [O] and
turn on at the socket.
2. Switch on the Power [I]. The current
temperature within the appliance is displayed.
Setting the Operating Temperature
1. Press the SET button. The display will flash.
2. Press the
or
buttons to display the
required temperature.
3. Press the SET button to store the temperature.

Internal Light

Press the
button on the controller to turn the
internal light on and off.
Manual Defrost
Press and hold the
button for 6 seconds to
begin or stop a manual defrost. The defrost light
illuminates.
Cleaning, Care &
Maintenance
Switch off and disconnect from the power
supply before cleaning.
Clean the interior of the appliance as often as
possible.
Do not use abrasive cleaning agents. These
can leave harmful residues.
Always wipe dry after cleaning.
A POLAR agent or qualified technician must
carry out repairs if required.
Cleaning the Condenser
Periodically cleaning the condenser can extend the
life of the appliance.
The condenser is located behind the front bottom
panel.
Note: Use a soft brush or
vacuum cleaner to clean the fins
of the condenser, taking care
not to damage the fins.
2019/7/30 13:51

Publicité

Table des Matières
loading

Table des Matières