Atag ES9111EM Mode D'emploi page 63

INSTALLATION
• Connect the bottom telescopic tube to the top tube. Fasten them to
each other temporarily but carefully with adhesive tape L.
• Unscrew the two screws O a maximum of 3 mm.
• Fasten the housing to the bottom telescopic tube, whereby the
screws O must be slid into the grooves of the bottom tube.
• Tighten the 3 supplied screws N and then the 2 screws O.
• I there is an external motor, this must be connected to the
connector box depicted opposite.
• Connect the motor in accordance with the diagram in the
connection box.
GB 15