Air Flow Velocity And Direction Adjustment - Mitsubishi Electric MCFZ-A12WV Notice D'utilisation

AIR FLOW VELOCITY AND DIRECTION ADJUSTMENT

AIR FLOW velocity and direction can be selected as required.
I
To change the AIR FLOW velocity, press the
Each time the button is pressed, the fan speed is changed in sequence:
(Low) →
• Use the
˚C
• If the operating sound of the air conditioner disturbs your sleep, use the
CLOCK
AMPM
12345
AMPM
I
To change the AIR FLOW blowing direction vertically, press the
TOO TOO
ON/OFF
VANE
WARM COOL
Each time the button is pressed, the angle of the horizontal vane is changed in
sequence: 1 → 2 → 3 → 4 → 5 →
FAN STOP
SWING OPERATION
I FEEL
HEAT AUTO
Use the swing operation for the air flow to reach all corners of the room.
VANE START
DRY COOL
MODE HR.
Recommended horizontal vane range
Use the
ECONO COOL MIN.
Use position 1 or 2 in the COOL or DRY mode and use
positions 3 to 5 in the HEAT mode when adjusting to
RESET CLOCK
your requirements.
NOTE:
• In the cooling operation, when the air conditioner is operated with setting the horizontal vane to 4 or 5 for 1 hour, the
AIR FLOW direction is automatically set to horizontal to prevent condensed water from dropping.
• Adjust the vertical AIR FLOW direction using the remote controller. If the horizontal vane is moved manually, it may
cause trouble.
• In the heating operation, if the air flow temperature is too low or when defrosting is being done, the horizontal vane
position is set to position 1.
I
To change the horizontal direction of the AIR FLOW
For the floor standing unit
• Change the direction of the vertical vane manually.
Adjust the vane before operation starts.
Since the horizontal vane moves automatically, your fingers may be caught.
8
FAN
(Med.) → (High) →
(AUTO)
(High) notch to cool/heat the room more.
(Low) notch.
button.
(SWING) →
(AUTO)
(AUTO) position usually.
For the ceiling suspended unit
• Change the direction of the vertical vane manually.
AUTO AIR FLOW DIRECTION CONTROL OPERATION
button.
When the AUTO mode is selected with the
spond to the operation mode for effective operation.
For the floor standing unit
(1) COOL, DRY
• The air is blown out upwards.
1
2
3 For the ceiling suspended unit
4
5
(1) COOL, DRY
• The air is blown out horizontally.
NOTE:
• When the operation mode changes in "
position in each mode.
VANE
button, the position of the horizontal vane is automatically set to corre-
(2) HEAT
• When the air flow temperature is • When the air flow temperature
too low, the air is blown out up- rises, the air is blown out hori-
wards. zontally.
(2) HEAT
• When the air flow temperature • When the air flow temperature
is too low, the air is blown out rises, the air is blown out down-
horizontally. wards.
(AUTO)" mode, the horizontal vane is automatically changed to the