Connect Power - Haier QWR04D R Série Instructions D'installation Et Guide De L'utilisateur

INSTALLATION INSTRUCTIONS
MOVE MAGNETIC SWITCH AND
CONNECT DOOR WIRING
Move the magnetic switch to the right mounting slot,
connect the door wiring and fasten the front trim of the
cabinet. (Remove from the left side opening)
Magnetic switch
CHECK DOOR FOR PROPER CLOSURE
Make sure the door is able to open and close in a good
condition.

CONNECT POWER

• Connect power cord plug to a properly grounded
receptacle.
• Make sure power is on by opening the door to see if
interior light turns on.
14
LEVEL
Adjustable legs at the front corners of the wine chiller
should be set so the wine chiller is firmly positioned on
the floor, with a 1/8" tilt to the back to help the door
closure.
To adjust the leveling legs, turn the legs
counterclockwise to raise the wine chiller, clockwise
to lower it.
To raise the appliance
SET TEMPERATURE CONTROLS
• The temperature controls are preset. Refer to the
Temperature Control section for more information.
Allow 24 hours for temperature to stabilize.
49-1000564 Rev. 0