Installation Instructions; Before You Begin - Haier QWR04D R Série Instructions D'installation Et Guide De L'utilisateur

INSTALLATION INSTRUCTIONS

BEFORE YOU BEGIN

Read these instructions completely and carefully.
IMPORTANT –
•
for local inspector's use.
IMPORTANT –
•
codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
future reference.
WARNING
• This appliance must be properly
• If you received a damaged wine chiller, you should
immediately contact your dealer or builder.
• Skill Level – Installation requires basic mechanical
skills. Proper installation is the responsibility of the
installer. Product failure due to improper installation is
TOOLS REQUIRED
• #2 Phillips screwdriver
• 5/16" (8mm) Hex nut driver
PARTS INCLUDED
ALTERNATE HINGE CAM
10
Save these instructions
Observe all governing
Be sure to leave these
Keep these instructions for
ALTERNATE DOOR CAM
ALTERNATE HINGE COVER
PRODUCT CLEARANCES
The wine chiller is factory set for a 105° door swing.
When installed in a corner:
• Allow 1" min. clearance on the hinge side for the 90°
door swing and to allow racks to slide out.
• Allow 8" minimum clearance on the hinge side for a full
105° door swing.
8" Minimum
to Wall
105°
Choose the location:
• Do not install the appliance where the temperature
will go below 55°F (13°C) because it will not run often
enough to maintain proper temperatures.
• Do not install the appliance where the temperature
will go above 90°F (32°C) because it will not perform
properly.
• Do not install the appliance in a location exposed to
water (rain, etc.) or direct sunlight.
• These products are not designed to be stacked one over
the other.
41-1/4"
90°
1" Minimum
to Wall
49-1000564 Rev. 0