Cleaning And Maintenance; What If There Are Problems; Disposal; Technical Specifications - Beurer MP 48 Mode D'emploi

9. Cleaning and maintenance

WARNING
Before beginning cleaning, pull the mains adapter out of the socket!
• Carefully clean the bottom of the device interior with a damp cloth after each use�
• Do not use any cleaning agents or solvents�

10. What if there are problems?

Problem
Nail dryer cannot be
switched on�
UV/LED nail gel
does not set�

11. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its
useful life�
Dispose of the device at a suitable local collection or recycling point� Dispose of the device in ac-
cordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment)�
If you have any questions, please contact the local authorities responsible for waste disposal�

12. Technical specifications

Model
Dimensions
Weight
Power supply
Light source wavelength range 365 - 395 nm
Device input
Voltage supply
Average active efficiency
Efficiency at low load (10%)
No-load power consumption
Subject to technical changes

13. Warranty / service

Beurer GmbH, Söflinger Straße 218, 89077 Ulm, Germany (hereinafter referred to as "Beurer") provides a
warranty for this product, subject to the requirements below and to the extent described as follows.
The warranty conditions below shall not affect the seller's statutory warranty obligations which
ensue from the sales agreement with the buyer.
The warranty shall apply without prejudice to any mandatory statutory provisions on liability.
Possible cause
Mains adapter not plugged in�
Female connector not inserted�
No voltage at mains socket�
Set application duration too
short�
MP 48
L 18�9 x W 16�5 x H 7�6 cm
approx� 330 g
100-240 V~, 50-60 Hz
24 V 1 A
Input: 100-240 V~, 50-60 Hz, 0�7 A
Output: 24�0 V
≥ 87�94 %
≥ 81�60 %
≤ 0�09 W
Solution
Plug the mains adapter into the socket�
Check that the female connector is positioned
correctly�
Check your fusebox�
Set a longer application duration on the nail
dryer� Set the application duration according to
the recommended setting time of the UV/LED
nail gel manufacturer�
1�0 A, 24�0 W
13