Device Overview; Top Of Device; Bottom Of Device; Operating Elements When Housing Cover Opened - brennenstuhl BREMATICPRO Mode D'emploi

Wireless water alarm 868.3 MHz

Device overview

Top of device

Bottom of device

Operating elements when housing cover opened

Preparation

Inserting the batteries

2 x 3 V Batteries (CR2450)
12 EN
Remove the housing cover.
Insert the batteries on top of each other into the battery
compartment with correct polarity (+ pole pointing upwards)
so that they can be fixed in place by the retaining collar.
Press the pair button.
Opening for
The battery status is fine if the device LED flashes.
Piezo buzzer
The electronics unit is ready for use.
Note: If the battery is drained, the device LED will flash once
every second.

Replacing the batteries

Remove the housing cover.
Press the battery retaining tab back.
Replace the batteries and close the housing cover until it audibly
clicks into place.
Adhesive pad
Sensor

Function

The wireless water detector is part of the Brennenstuhl Home Automation
Systems BrematicPRO, controlled via app or the BrematicPRO PC software.
The wireless water detector, with the help of two sensors on the bottom
of the device, detects the presence of water indoors and notifies the
BrematicPRO Gateway of this. Additionally, an alarm is emitted
acoustically through the Piezo signal transmitter. The water level sensor
is triggered by a water level of over 1 mm. The device is battery-powered.
For this reason, it is flexible and can be used in any location.
Note: A water level of 1.5 cm or above may result in water entering
the device. You will have to replace the wireless water detector if
Piezo buzzer
water enters it.
Device LED
Pair button
Battery

Setting up the wireless water detector

compartment
Place the wireless water detector onto a stable, level surface.
Avoid soft surfaces e.g. carpets.
Ensure that the wireless water detector is within the range of
the BrematicPRO Gateway.
Test the reception at different times of the day to take into
account potential radio interference at different times of the day.
If you want to prevent the water detector from accidentally
shifting, use the adhesive pad enclosed to affix the water detector.

Download app / PC software BrematicPRO

The Brennenstuhl Home Automation System BrematicPRO is controlled
via the BrematicPRO app/PC software. The app can be downloaded for
free from the App Store and Google Play. The PC software is available
for download at www.brematic.com/en/service.