Bosch ART 23 G Instructions D'emploi page 18

Masquer les pouces Voir aussi pour ART 23 G:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
EURO • Printed in England • BA F016 L69 913 • ART 23/25 • GB • OSW 02.07
F016 L69 913.book Seite 6 Dienstag, 23. Juli 2002 11:37 11
Accessories
Line spool
ART 23 G
ART 23 GF/GFS/GFSV
ART 25 GSA/GSAV/ERGOPOWER F 016 800 050
Line refill (24 m)
ART 23 G/GF/GFS/GFSV
(1.4 mm)
ART 25 GSA/GSAV/ERGOPOWER
(1.6 mm)
Fault Finding
The following table gives checks and actions that you can perform if your machine does not operate correctly.
If these do not identify/remedy the problem, contact your service agent.
Warning: Switch off and remove plug from mains before investigating fault.
Symptom
Machine fails to operate
Machine functions
intermittently
Machine labours
Machine is not cutting
Line can't be fed
automatically
Environmental Protection
The machine has been assembled in
an environmentally responsible way.
Recycle raw materials instead of
disposing as waste.
Machine, accessories and packaging
should be sorted for environment-
friendly recycling.
18 • F016 L69 913 • TMS • 16.07.02
F 016 800 001
F 016 800 002
F 016 800 003
F 016 800 052
Possible Cause
Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Extension cable damaged
Machines internal wiring damaged
Grass too high
Line too short/broken off
Spool empty
Line inside the spool entangled
English - 6
After Trimming/Storage
Stop and remove plug from the power sup-
ply.
Clean the exterior of the machine thoroughly using a
soft brush and cloth. Do not use water, solvents or
polishes. Remove all grass and debris, especially
from the ventilation slots 7.
Turn the machine on its side and clean the cutting
guard 8 inside. If grass cuttings are compacted, re-
move with a wooden or plastic implement.
Remedy
Turn power on
Use another socket
Inspect cable, replace if damaged
Replace fuse
Inspect cable, replace if damaged
Contact Service Agent
Cut in stages
Feed the line manually/automatically
Replace the spool
Inspect the spool, rewind if necessary
These instructions are printed on re-
cycled paper manufactured without
chlorine.
The plastic components are labelled
for categorized recycling.
When the time comes to dispose of this product,
please consider the environment and take it to a rec-
ognized recycling facility (please contact your local
authority for location information).

Publicité

Table des Matières
loading

Table des Matières