Leica SUPER-VARIO-ELMAR-SL 1:3.5-4.5/16-35 ASPH Notice D'utilisation page 15

Bayonet fitting
Filter mount / lens hood
Finish
Dimensions and weight
Length of the bayonet flange
Largest diameter
Weight
make sure to support the combined weight of
1
the lens with the other. That way, the strain on the bayonet fitting will be minimized.
The nominal focal lengths of the Leica SL lenses are based on the 35 mm-format, i.e. on an original format of 24 x 36 mm.
2
Leica TL and CL models
The sensor for
view angle of the lenses on these cameras will therefore match that of objectives with a longer focal length by a factor of
approx. 1.52 (1.52 ≈ inverse of 0.66).
Function is slowed when used with a Leica (Typ 701).
3
MTF (see Appendix) is stated for full aperture and for apertures 5.6 and 8 for large shooting distances (infinity). Contrast is
applied in percentage values for 5, 10, 20, 40 Lp/mm via the format height for tangential (dotted line) and sagittal (solid
line) structures in white light. The 5 and 10 Lp/mm settings offer insights into the contrast behavior for coarser object
structures, while 20 and 40 Lp/mm show the resolution capacity for fine and the finest object structures.
Leica L bayonet fitting with contact strip
External male bayonet for lens hood (included), internal thread for E82
filters, non-rotating filter mount
Black, anodized
approx. 123/152 mm (with/without lens hood)
approx. 88 mm (lens hood (W x H) 126 x 97 mm)
approx. 990 g
camera
and add-on lens by holding the body of the camera in one hand and
is comparatively smaller at 23.6 x 15.7 mm (by approx. a factor of 0.66). The
EN
13