Assembling Your Tilt-Head Stand Mixer - KitchenAid Classic Série Mode D'emploi

ASSEMBLING YOUR TILT-HEAD STAND MIXER

WARNING
Electrical Shock Hazard
Plug into a grounded
3 prong outlet.
Do not remove
ground prong.
Do not use an adapter.
Do not use an
extension cord.
Failure to follow these
instructions can result
in death, fire, or
electrical shock.
Off
To Attach Bowl
1.
Turn speed control to OFF.
2.
Unplug Stand Mixer or
disconnect power.
3.
Tilt motor head back.
4.
Place bowl on bowl
clamping plate.
5.
Turn bowl gently into
clockwise direction.
6. Plug into a grounded
3 prong outlet.
To Remove Bowl
1.
Turn speed control to OFF.
2.
Unplug Stand Mixer or
disconnect power.
3.
Tilt motor head back.
4.
Turn bowl counterclockwise.
To Attach Flat Beater, Wire Whip, or
Dough Hook
1. Turn speed control to OFF.
2.
Unplug Stand Mixer or
disconnect power.
3. Tilt motor head back.
4.
Slip beater onto beater shaft and
press upward as far as possible.
5. Turn beater to right, hooking beater
over pin on shaft.
6. Plug into a grounded 3 prong outlet.
To Remove Flat Beater, Wire Whip or
Dough Hook
1. Turn speed control to OFF.
2.
Unplug Stand Mixer or
disconnect power.
3. Tilt motor head back.
4.
Press beater upward as far as
possible and turn left.
5. Pull beater from beater shaft.
On
Pin
Continued on next page
11