PNI P15UV Manuel Utilisateur page 21

Manual programming (Channel memory)
Frequently used frequencies can be stored so that they can be used whenever needed.
250 memories are available. Each memory can store the following information: transmission
and reception frequency, transmission power, bandwidth, ANI/PTT-ID settings, alphanumeric
identifier (6 characters) of the channel or channel name.
Frequency mode vs. channel mode
Long press the MENU key to switch between frequency mode and channel mode. These two
modes have different functions and are often confused.
Frequency mode (VFO): is used for temporary frequency allocation, such as a test frequency
or fast field programming.
Channel mode (MR): used to select pre-programmed channels.
Example no. 1
Programming a CTCSS tone repeater channel offset
Save on channel 10:
RX = 432.55000 MHz
TX = 437.55000 MHz (+ 5) Offset
Tone TX CTCSS 123.0
21 User manual