Part Names And Functions; Front Panel - Denon DRA-395 Mode D'emploi

ENGLISH
• This unit is equipped with a high-speed protection circuit. This circuit protects the internal circuitry from damage due to
large currents flowing if the speaker jacks are not completely connected or if an output is generated by a short circuit.
In such a case, the protection circuit will operate to cut off the output to the speakers. Should this happen, turn the
power off and check the speaker connections. Then turn the power on again. After muting for several seconds, the
receiver should be operating normally.
If the protection circuit is activated again even though there are no problems with the wiring or the ventilation around
the unit, switch off the power and contact a DENON service center.
• The protector circuit may be activated if the set is played for long periods of time at high volumes when speakers with
an impedance lower than the specified impedance (for example speakers with an impedance of lower than 4 Ω/ohms)
are connected. If the protector circuit is activated, the speaker output is cut off. Turn off the set's power, wait for the set
to cool down, improve the ventilation around the set, then turn the power back on.

6 PART NAMES AND FUNCTIONS

Front Panel

• For details on the functions of these parts, refer to the pages given in parentheses ( ).
B
ON / STANDBY
q
q
Power operation switch ....................................................(13, 21)
w
Headphone jacks (PHONES) ...................................................(19)
e
SPEAKER A/B buttons ................................................(13, 19, 24)
r
REC/MULTI buttons ..........................................................(17, 18)
t
LOUDNESS button..................................................................(15)
y
VIDEO SELECT button ............................................................(19)
u
TONE DEFEAT button.............................................................(15)
i
CH VOL button........................................................................(15)
o
SELECT UP/DOWN buttons....................................................(15)
!0
BASS button............................................................................(15)
!1
TREBLE button.......................................................................(15)
10
Note on speaker impedance
@1 @0 !9
DRA-395
PRECISION AUDIO COMPONENT / STEREO RECEIVER
CD PHONO
REMOTE
SENSOR
Multi Room
TUNER DVD / VDP
Music Entertainment System
ON / STANDBY ZONE 2 ZONE 3
VCR
CDR / TAPE V.AUX
SHIFT DOWN UP
PRESET
PHONES SPEAKER
REC OUT
A B
w e
Protector circuit
!8 !7 !6 !5
BAND MODE MEMORY DOWN UP VIDEO SELECT
TUNING
REC / MULTI
ZONE 2 ZONE 3 SELECT LOUDNESS
r t y
!2
MASTER VOLUME control .....................................................(14)
!3
STATUS button .......................................................................(20)
!4
DIMMER button......................................................................(20)
!5
MASTER VOLUME indicator (VOLUME LEVEL) .....................(14)
!6
Display
!7
Tuning/Preset memory selector buttons ........................(21〜 23)
!8
ZONE 2, 3 indicator .................................................................(18)
!9
Remote control sensor (REMOTE SENSOR) ..........................(11)
@0
Power indicator .......................................................................(13)
@1
Input source selector buttons ...........................................(14, 22)
!4 !3 8 !2 !1
MASTER VOLUME
VOLUME LEVEL
DIMMER STATUS
TONE
SELECT TREBLE
DEFEAT
UP
DOWN
CH VOL BASS
u i o !0