Setting The Head Locking System; Installing Or Removing The Dispensing Or Tear-Off Plate - HellermannTyton TT4030 Manuel D'utilisation

Operation

6 .3 Setting the head locking system

The printhead is pressed on by two plungers. The
position of the two plungers must be adapted to the
width of the utilised material to
• achieve uniform print quality across the entire material
width,
• avoid wrinkles in the colour ribbon feed,
• prevent premature wear of the print roller and the
printhead.
Set the head locking system.
1 Grub screw
2 Plunger
3 Printhead locking lever
1 Loosen the grub screws of the two plungers using the
Allen key and adjust the two plungers to the width of
the material.
2 Turn the lever clockwise to lock the printhead.
3 Tighten the threaded pins.
4 Apply pressure on the printhead with the two plungers,
whose basic position is in the middle of the printhead
retainer.
; The head locking system is set.
This setting can be used for all applications
14
1
2
3
.
Operating Instructions • Thermal Transfer Printer TT4030 • 06-2017 • 031-93478
6 .4 Installing or removing the dispensing or tear-off
plate
To convert the device for a different operating mode, a
dispensing plate or tear-off plate must be installed if
necessary.
1
Dispensing plate or tear-off plate.
1 Dispensing plate (only included with the dispenser version)
2 Tear-off plate
1
2
3
2
4
Installing and removing the dispensing plate or tear-off plate.
1 Screw
2 Pin
3 Plate
4 Cover
1 Remove the plate.
f Open the cover.
f Loosen the screw by several turns.
f Push the plate upwards.
f Remove the plate.
; The plate is removed.
2 Install the plate.
f Insert the plate on the screw.
f Push the plate down behind the pin.
f Tighten the screw.
; The plate is installed.
2